Maintenance And Care Tips For Portable Air Conditioners
Portable Air Conditioner clients have questions about the maintenance and care that the unit requires so as to run appropriately and last a very long time. Whenever you decide on any cooling solution, you wish to be sure that you get the best from your unit.
Below are a few tips and suggestions to do just that for you.
Location, Location, And Location
Firstly, you will wish to examine where you will exactly be installing and utilizing the unit. Placement tends to be very essential to longevity of the portable AC unit. Try and avoid areas which are very dirty or dusty. The reason for it is that the dust can get in the lower and upper fan motors, contaminate bearings, and foul windings on motors themselves. It can cause mechanical and electrical failures.
If the dusty areas are actually unavoidable, consider utilizing antimicrobial filter with the portable air conditioners. This will assist capture and alleviate all the impurities.
The other things you should consider include the proximity to any available window and nearby power source. The window is required for venting purposes, whereas a power source tends to be necessary to run your unit. If the window isn’t available, consider using ceiling tile or sliding glass door as a venting outlet.
If the area is especially humid, you might also wish to consider a close by drain for condensate that air conditioner will collect during operation.
When it comes to power, ensure that the system is being run on a circuit which will supply about 120VAC, at minimum 15A. It’ll ensure that the fan and compressor motors have lots of startup power. Next thing to consider include the use of electrical surge protector. The cost is minimum and will save you effort, money, and time in the case you face a power surge.
Cleaning of the air conditioner unit’s filters regularly will go a very long way in guarantying long life of your appliance. Regular cleaning of washable pre-filter is suggested, usually located in upper back part of the system. This will avoid dirt and dust from building up onto the evaporator coils.
If dirt is ever allowed to collect, it mixes with residual moisture on coil and forms “crust”, or dirty layer, on coil, which prevents it eventually from transferring heat from room to outside, acting as insulator and causing compressor to overheat. Ensure while cleaning the filters to not use detergents or soap as they will definitely leave sticky film on filter and lead to rapid clogging.
Make sure to keep all the vents also in back of the system clean as fans pull air via the vents to offer secondary cooling of compressor. You may utilize a vacuum with brush attachment to attain this job if you want.
In addition make sure that while installing exhaust hose, it is as straight and as short as probable. You do not want to ever extend hose to its own maximum length or even kink hose in any ways. This will avoid the moisture in exhaust stream from ever condensing in hose and rolling out back into the system, potentially causing damages.
After cooling season is gone, you will wish to drain the system of collect water and then operate your unit in the FAN ONLY mode, that too on a HIGH speed, for about 3-4 hours, to fully dry the inside part of the unit. Cover the whole unit with plastic sheets and store in dry and cool place where it won’t be subjected to any freezing conditions or contact AC Repair Queen Creek if facing any issues.